TRANSMISSION WIRE INSTALLATION

PROCEDURE


  1. INSTALL TRANSMISSION WIRE


    1. Coat the O-ring of the transmission wire connector with ATF.

    2. A01X90P

      Install the transmission wire with the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }
    3. A01X25I

      Connect the transmission wire connector.

      Tech Tips

      Push up the lever until the claw of the transmission wire connector makes a connection sound.

  2. CONNECT TRANSMISSION WIRE


    1. A01X5AGE09
      *1 Orange
      *2 Blue

      Connect the 7 connectors to the solenoid valves.

    2. Connect the 2 ATF temperature sensors with the 2 clamps and 2 bolts.

      Torque:
      for bolt A
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }
      for bolt B
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

      Tech Tips

      Each bolt length is indicated below.

      12 mm (0.472 in.) for bolt A

      36 mm (1.42 in.) for bolt B

  3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

    A01XA2D

    1. Coat a new O-ring with ATF and install it to the oil strainer.

    2. Install the oil strainer with the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

    A01XBDK

    Note

    Remove the gasket and be careful not to spill oil on the contacting surfaces of the transmission case and oil pan.


    1. Install a new gasket and the oil pan with the 20 bolts.

      Torque:
      4.4 N*m  { 45 kgf*cm, 39 in.*lbf }

  5. ADD AUTOMATIC TRANSMISSION FLUID


    1. Add automatic transmission fluid Click here.