TRANSMISSION WIRE REMOVAL

PROCEDURE


  1. DRAIN AUTOMATIC TRANSMISSION FLUID


    1. Remove the drain plug and gasket, and drain the ATF.

    2. Install a new gasket and the drain plug.

      Torque:
      20 N*m  { 204 kgf*cm, 15 ft.*lbf }

  2. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


    1. A01XBDK

      Remove the 20 bolts, oil pan and gasket from the transmission.

      Note

      Some fluid will remain in the oil pan. Remove all the pan bolts, and carefully remove the oil pan assembly.

    2. A01X7N7

      Examine the particles in the pan.


      1. Remove the 4 magnets and use them to collect steel particles. Carefully inspect the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the transmission.

        Steel (magnetic): bearing, gear and clutch plate wear

        Brass (non-magnetic): bush wear

  3. REMOVE VALVE BODY OIL STRAINER ASSEMBLY


    1. A01XA2D

      Remove the 4 bolts and oil strainer.

      Note

      Be careful as some fluid may leak out of the oil strainer.

    2. Remove the O-ring from the oil strainer.

  4. DISCONNECT TRANSMISSION WIRE

    A01X5AG

    1. Remove the 2 bolts and 2 temperature sensor clamps.

    2. Disconnect the ATF temperature sensors.

    3. Disconnect the 7 connectors from the solenoid valves.

  5. REMOVE TRANSMISSION WIRE

    A01X8GQ

    1. Disconnect the wire connector.


      1. Detach the claw, press down the lever, and then disconnect the transmission wire connector.

    2. A01X90P

      Remove the bolt and pull out the transmission wire.