SHIFT LEVER INSPECTION

PROCEDURE


  1. INSPECT TRANSMISSION CONTROL SWITCH

    B00203TE33
    *1 Component without harness connected: (Transmission Control Switch)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      3 (IG) - 7 (S) Shift lever in S, "+" or "-" Below 1 Ω
      2 (SFTU) - 5 (E) Shift lever held in "+" (Up-shift)
      1 (SFTD) - 5 (E) Shift lever held in "-" (Down-shift)
      3 (IG) - 7 (S) Shift lever not in S, "+" or "-" 10 kΩ or higher
      2 (SFTU) - 5 (E) Shift lever in S
      1 (SFTD) - 5 (E)

      If the result is not as specified, replace the transmission floor shift assembly.