Click here

DYNAMIC RADAR CRUISE CONTROL SYSTEM Distance Control Switch Circuit

Click here
Click here
DTC Code DTC Name
  Distance Control Switch Circuit
Click here

DESCRIPTION

The driving support ECU assembly receives a lane departure alert main switch signal from the steering pad switch assembly and sends the signal to the forward recognition camera via CAN communication.

Click here

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note:

  • The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System (Click here).

  • When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.

Click here

PROCEDURE


  1. Click here

    INSPECT STEERING PAD SWITCH ASSEMBLY


    1. Remove the steering pad switch assembly (Click here).

    2. Inspect the steering pad switch assembly (Click here).


  2. Click here

    INSPECT SPIRAL CABLE SUB-ASSEMBLY


    1. Remove the spiral cable sub-assembly (Click here).

    2. Inspect the spiral cable sub-assembly (Click here).


  3. Click here

    CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - DRIVING SUPPORT ECU ASSEMBLY)


    1. Disconnect the E122 spiral cable sub-assembly connector.

    2. Disconnect the E164 driving support ECU assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      E122-12 (DIST) - E164-23 (SPSW) Always Below 1 Ω
      E122-12 (DIST) or E164-23 (SPSW) - Body ground Always 10 kΩ or higher
      Result
      Result Proceed to
      OK (for 3UR-FE) A
      OK (except 3UR-FE) B
      NG C

  4. Click here

    CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - ECM)


    1. Disconnect the E122 spiral cable sub-assembly connector.

    2. Disconnect the A38 ECM connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      E122-2 (ECC) - A38-59 (ECCS) Always Below 1 Ω

    • OKClick here
    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR

  5. Click here

    CHECK HARNESS AND CONNECTOR (ECM- BODY GROUND)


    1. Disconnect the C45 ECM connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      C45-81 (E1) - Body ground Always Below 1 Ω

    • OK

      PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR

  6. Click here

    CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - BODY GROUND)


    1. Disconnect the E122 spiral cable sub-assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      E122-2 (ECC) - Body ground Always Below 1 Ω

    • OK

      PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR