DYNAMIC RADAR CRUISE CONTROL SYSTEM, Diagnostic DTC:C1A52

DTC Code DTC Name
C1A52 Driving Support ECU Communication Abnormal

DESCRIPTION

DTC C1A52 is stored when the ECM cannot recognize the driving support ECU assembly.

DTC No. DTC Detection Condition Trouble Area
C1A52 Approximately 17 seconds after the engine switch is turned on (IG), the ECM cannot recognize the driving support ECU assembly for approximately 1.3 seconds or more.

  • ECM

  • Driving support ECU assembly

CAUTION / NOTICE / HINT

Note


  • When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.

  • First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed with troubleshooting Click here.

PROCEDURE


  1. CHECK FOR DTCs (RADAR CRUISE2)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Clear the DTCs Click here.

    4. Make sure that the DTC detection conditions are met.

      Tech Tips

      If the detection conditions are not met, the system cannot detect the malfunction.


      • Turn the engine switch on (IG) and wait approximately 20 seconds or more.

    5. Enter the following menus: Powertrain / Radar Cruise2 / Trouble Codes.

    6. Check for DTCs Click here.

      Result
      Result Proceed to
      DTC C1A52 is output A
      DTC C1A52 is not output B

    B

    USE SIMULATION METHOD TO CHECK

    A

  2. REPLACE ECM


    1. Replace the ECM.



    NEXT

  3. CHECK FOR DTCs (RADAR CRUISE2)


    1. Connect the GTS to the DLC3.

    2. Turn the engine switch on (IG).

    3. Clear the DTCs Click here.

    4. Make sure that the DTC detection conditions are met.

      Tech Tips

      If the detection conditions are not met, the system cannot detect the malfunction.


      • Turn the engine switch on (IG) and wait approximately 20 seconds or more.

    5. Enter the following menus: Powertrain / Radar Cruise2 / Trouble Codes.

    6. Check for DTCs Click here.

      Result
      Result Proceed to
      DTC C1A52 is output A
      DTC C1A52 is not output B

    A

    REPLACE DRIVING SUPPORT ECU ASSEMBLY Click here

    B

    END (ECM WAS DEFECTIVE)