LIN COMMUNICATION SYSTEM, Diagnostic DTC:B2786

DTC Code DTC Name
B2786 No Response from Steering Lock ECU

DESCRIPTION

This DTC is stored when LIN communication between the certification ECU (smart key ECU assembly) and steering lock actuator (steering lock ECU) stops for 10 seconds or more.

DTC Code DTC Detection Condition Trouble Area
B2786 Periodic transmission from the steering lock ECU stops for 10 seconds or more.

  • Steering lock actuator (Steering lock ECU)

  • Certification ECU (smart key ECU assembly)

  • Harness or connector

WIRING DIAGRAM

B001X6UE01

CAUTION / NOTICE / HINT

Note


  • When using the GTS with the ignition switch off to troubleshoot:

    Connect the GTS to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the GTS and vehicle begins.

  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

Tech Tips

DTC B2785 is stored when the communication between the steering lock ECU and certification ECU (smart key ECU assembly) stops.

PROCEDURE


  1. CLEAR DTC


    1. Clear the DTC Click here.


    NEXT

  2. CHECK FOR DTC


    1. Recheck for DTCs Click here.

      Result
      Result Proceed to
      DTC B2786 is output A
      DTC B2786 is not output B

    B

    USE SIMULATION METHOD TO CHECK Click here

    A

  3. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - STEERING LOCK ECU)


    1. Disconnect the E26 and E130 ECU connectors.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      E130-6 (LIN) - E26-5 (LIN) Always Below 1 Ω
      E130-6 (LIN) or E26-5 (LIN) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  4. CHECK HARNESS AND CONNECTOR (STEERING LOCK ACTUATOR ASSEMBLY BATTERY AND BODY GROUND)


    1. B001WI9E01
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Steering Lock Actuator [Steering Lock ECU])

      Disconnect the E26 ECU connector.

    2. Measure the resistance and voltage according to the value(s) in the tables below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      E26-1 (GND) - Body ground Always Below 1 Ω
      Standard Voltage
      Tester Connection Condition Specified Condition
      E26-7 (B) - Body ground Always 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  5. REPLACE STEERING LOCK ACTUATOR ASSEMBLY


    1. for Manual Tilt and Manual Telescopic Steering Column


      1. Temporarily replace the steering lock actuator with a new or normally functioning one Click here.

    2. for Power Tilt and Power Telescopic Steering Column


      1. Temporarily replace the steering lock actuator with a new or normally functioning one Click here.

    3. Clear the DTC Click here.


    NEXT

  6. CHECK FOR DTC


    1. Recheck for DTCs Click here.

      Result
      Result Proceed to
      DTC B2786 is not output A
      DTC B2786 is output B

    A

    END (STEERING LOCK ACTUATOR ASSEMBLY IS DEFECTIVE)

    B

    REPAIR OR REPLACE HARNESS OR CONNECTOR