GENERATOR(for 130 A Type) REMOVAL

Click here Click here

PROCEDURE

1. Click here

   PRECAUTION

   Note:

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

2. Click here

   DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

3. Click here

   REMOVE V-BANK COVER

   Click here

4. Click here

   REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

   Click here

5. Click here

   REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

   Click here

6. Click here

   REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

   Click here

7. Click here

   REMOVE FAN AND GENERATOR V BELT

   Click here

8. Click here

   REMOVE FRONT FENDER APRON TRIM PACKING B

   Click here

9. Click here

   REMOVE GENERATOR ASSEMBLY

   
   
   1. 

      Disconnect the generator connector.

   2. Open the terminal cap.

   3. Remove the nut and disconnect the generator wire from terminal B.

   4. Remove the bolt and disconnect the wire harness clamp bracket.

   5. 

      Remove the bolt and disconnect the generator bracket.

   6. 

      Remove the 2 bolts and generator.

   7. 

      Remove the bolt and generator bracket.