FRONT AND SIDE MONITOR MAIN SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. DISABLE AUTO TILT AWAY FUNCTION


    1. Disable the function by changing the customize parameter Click here.

      Note

      Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      Tech Tips

      Performing the above operation causes the Autoaway/Return function to be disabled when the engine switch is turned off.

    2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.

    3. Turn the engine switch off.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE INSTRUMENT SIDE PANEL LH

    Click here

  4. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Click here

  5. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

    Click here

  6. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

    Click here

  7. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Click here

  8. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. A01WZZ1

      Detach the 4 claws.

    2. A01X74N

      Detach the 9 claws.

    3. w/ Multi-information Display:

      Remove the finish panel and disconnect the 2 connectors.

    4. w/o Multi-information Display:

      Remove the finish panel and disconnect the connector.

  9. REMOVE MAIN SWITCH ASSEMBLY


    1. A01X0QFE01
      Text in Illustration
      *A for LHD
      *B for RHD

      Detach the 2 claws and remove the main switch assembly.