GENERATOR(for 100 A Type) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE V-BANK COVER

    Click here

  4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

    Click here

  5. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here

  6. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  7. REMOVE FAN AND GENERATOR V BELT

    Click here

  8. REMOVE FRONT FENDER APRON TRIM PACKING B

    Click here

  9. REMOVE GENERATOR ASSEMBLY


    1. B001ZQ5

      Disconnect the generator connector.

    2. Open the terminal cap.

    3. Remove the nut and disconnect the generator wire from terminal B.

    4. Remove the bolt and disconnect the wire harness clamp bracket.

    5. B001ZC3

      Remove the bolt and disconnect the generator bracket.

    6. B001XT9

      Remove the 2 bolts and generator.

    7. B001Z2S

      Remove the bolt and generator bracket.