MULTI-TERRAIN MONITOR SYSTEM, Diagnostic DTC:C1625

DTC Code DTC Name
C1625 Open or Short in Steering Angle Sensor +B

DESCRIPTION

This DTC is stored if the parking assist ECU receives a signal via CAN communication from the steering sensor that indicates a power supply system problem.

DTC Code DTC Detection Condition Trouble Area
C1625 Open or short in steering angle sensor +B

  • Harness or connector

  • Spiral with sensor cable sub-assembly

WIRING DIAGRAM

B001WPUE02

CAUTION / NOTICE / HINT

Note


  • When "!" mark is displayed on the multi-display after the battery terminal disconnected, correct the steering angle neutral point Click here.

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the multi-terrain monitor system may be needed Click here.

  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

  • The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags.

    Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System Click here.

  • The multi-terrain monitor system troubleshooting procedure is based on the premise that the VGRS system is operating normally. Check the VGRS system first before troubleshooting the multi-terrain monitor system Click here.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY - BATTERY AND BODY GROUND)


    1. B001XEIE02
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Spiral with sensor cable sub-assembly)

      Disconnect the spiral with sensor cable sub-assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      E163-1 (ESS) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      E163-4 (IG) - E163-1 (ESS) Engine switch on (IG) 11 to 14 V
      E163-5 (BAT) - E163-1 (ESS) Always 11 to 14 V

    OK

    REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR