BLIND SPOT MONITOR SYSTEM, Diagnostic DTC:U0232

DTC Code DTC Name
U0232 Lost Communication with Blind Spot Monitor Slave Module

DESCRIPTION

This DTC is stored when the blind spot monitor sensor LH judges that there is a communication error with the blind spot monitor sensor RH.

DTC No. DTC Detection Condition Trouble Area
U0232 The blind spot monitor sensor LH cannot receive signals from the blind spot monitor sensor RH.

  • CAN communication Line

  • Blind spot monitor sensor LH

  • Blind spot monitor sensor RH

WIRING DIAGRAM

A01XAV4E69

CAUTION / NOTICE / HINT

Note


  • When checking for DTCs, make sure that the blind spot monitor main switch (steering pad switch assembly [multi-function switch]) is on.

  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - BLIND SPOT MONITOR SENSOR LH)


    1. Disconnect the r1 blind spot monitor sensor RH connector.

    2. Disconnect the r2 blind spot monitor sensor LH connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      r1-6 (CA2P) - r2-1 (CA2P) Always Below 1 Ω
      r1-1 (CA2N) - r2-8 (CA2N) Always Below 1 Ω

    NG

    REPAIR OR REPLACE CAN LINE OR CONNECTOR

    OK

  2. CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - BATTERY AND BODY GROUND)


    1. A01X1XYE01
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Blind Spot Monitor Sensor RH)

      Disconnect the r1 blind spot monitor sensor RH connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      r1-10 (BRGD) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      r1-5 (BRB) - Body ground Engine switch on (IG) 11 to 14 V

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. REPLACE BLIND SPOT MONITOR SENSOR RH


    1. Replace the blind spot monitor sensor RH Click here.


    NEXT

  4. RECHECK DTC


    1. Clear the DTCs Click here.

    2. Recheck for DTCs and check if the same DTC is output again.

      OK
      No DTCs are output.

    OK

    END (BLIND SPOT MONITOR SENSOR RH WAS DEFECTIVE)

    NG

    REPLACE BLIND SPOT MONITOR SENSOR LH Click here