PARKING ASSIST MONITOR SYSTEM(w/o Side Monitor System), Diagnostic DTC:C1625

DTC Code DTC Name
C1625 Open or Short in Steering Angle Sensor +B

DESCRIPTION

This DTC is stored if the navigation receiver assembly receives a signal via CAN communication from the steering sensor that indicates a power supply problem.

DTC Code DTC Detection Condition Trouble Area
C1625 Open or short in steering angle sensor +B

  • Harness or connector

  • Steering sensor

WIRING DIAGRAM

A01X1GYE02

CAUTION / NOTICE / HINT

Note


  • Since the parking assist monitor system (w/o Side Monitor System) has functions that use CAN communication system, first confirm that there is no malfunction in the communication system by inspecting the CAN communication functions in accordance with the "How to Proceed with Troubleshooting" procedures. Then, conduct the following inspection procedure.

  • When "System initializing" is displayed on the navigation receiver assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point Click here.

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system (w/o Side Monitor System) may be needed Click here.

  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (STEERING SENSOR - BATTERY AND BODY GROUND)


    1. A01X2E5E02
      Text in Illustration
      *a

      Front view of wire harness connector

      (to Steering Sensor)

      Disconnect the E11 connector from the steering sensor.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      E11-2 (ESS) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      E11-1 (IG) - E11-2 (ESS) Engine switch on (IG) 11 to 14 V
      E11-3 (BAT) - E11-2 (ESS) Always 11 to 14 V

    OK

    REPLACE STEERING SENSOR Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR