PARKING ASSIST MONITOR SYSTEM, Diagnostic DTC:C1625

DTC Code DTC Name
C1625 Open or Short in Steering Angle Sensor +B

DESCRIPTION

This DTC is stored if the rear television camera assembly receives a signal via CAN communication from the spiral with sensor cable sub-assembly that indicates a power supply problem.

DTC Code Detection Item DTC Detection Condition Trouble Area
C1625 Open or Short in Steering Angle Sensor +B Open or short in spiral with sensor cable sub-assembly power source

  • Harness or connector

  • Spiral with sensor cable sub-assembly

WIRING DIAGRAM

B001Y26E14

CAUTION / NOTICE / HINT

Note


  • When "System initializing" is displayed on the multi-display after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point Click here.

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed Click here.

  • Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY - BATTERY AND BODY GROUND)


    1. B001YENE02
      Text in Illustration
      *A w/ Variable Gear Ratio Steering System
      *B w/o Variable Gear Ratio Steering System
      *a

      Front view of wire harness connector

      (to Spiral with Sensor Cable Sub-assembly)

      Disconnect the E163*1 or E121*2 spiral with sensor cable sub-assembly connector.


      • *1: w/ Variable Gear Ratio Steering System

      • *2: w/o Variable Gear Ratio Steering System

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      w/ Variable Gear Ratio Steering System
      Tester Connection Condition Specified Condition
      E163-1 (ESS) - Body ground Always Below 1 Ω
      Standard Resistance
      w/o Variable Gear Ratio Steering System
      Tester Connection Condition Specified Condition
      E121-1 (ESS) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      w/ Variable Gear Ratio Steering System
      Tester Connection Condition Specified Condition
      E163-4 (IG1) - E163-1 (ESS) Engine switch on (IG) 11 to 14 V
      E163-5 (BAT) - E163-1 (ESS) Always 11 to 14 V
      w/o Variable Gear Ratio Steering System
      Tester Connection Condition Specified Condition
      E121-4 (IG1) - E121-1 (ESS) Engine switch on (IG) 11 to 14 V
      E121-8 (BAT) - E121-1 (ESS) Always 11 to 14 V

    OK

    REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR