FUEL PUMP REASSEMBLY

CAUTION / NOTICE / HINT

Note

Do not disconnect the hoses indicated in the illustration.

B001YL9E02
Text in Illustration
*a for Single Tank Type *b for Double Tank Type

PROCEDURE


  1. INSTALL NO. 1 FUEL SUCTION SUPPORT


    1. Attach the 2 claws to the claw holes to install the fuel suction support.

  2. INSTALL FUEL MAIN VALVE ASSEMBLY


    1. B001ZUHE19
      Text in Illustration
      *1 New O-Ring

      Apply a light coat of gasoline to 2 new O-rings, and install them onto the fuel main valve.

    2. B001W8DE02
      Text in Illustration
      *1 Fuel Filter Case
      *2 O-Ring

      Install the fuel main valve to the fuel filter case.

      Note

      Make sure the O-rings are not cut or pinched during the installation.

  3. INSTALL FUEL PUMP


    1. A01X9A2

      Connect the fuel pump wire harness connector to the fuel pump.

    2. B00205GE02
      Text in Illustration
      *1 O-Ring
      *2 Spacer

      Apply a light coat of gasoline to a new O-ring. Then install the O-ring and spacer to the fuel pump.

    3. Attach the 5 claws to the claw holes and install the fuel pump to the fuel filter case.

  4. INSTALL NO. 1 FUEL SUB-TANK (for Single Tank Type)

    Note

    Make sure that the fuel tube passes into the section marked by the circle.

    B001WSJE02
    Text in Illustration
    *1 Fuel Tube

    1. Attach the 3 claws to the claw holes to install the No. 1 fuel sub-tank.

    2. Attach the 3 claws to the claw holes.

    3. Install the tube part to the No. 1 fuel sub-tank.


      1. Attach the claw on the end of the tube to the claw hole. Install the tube to the 2 clamps on the No. 1 fuel sub-tank.

    4. Connect the jet pump to the No. 1 fuel sub-tank.

    5. Connect the fuel pump connector.

  5. INSTALL NO. 1 FUEL SUB-TANK (for Double Tank Type)

    B001WSJE02
    Text in Illustration
    *1 Fuel Tube

    Note

    Make sure that the fuel tube passes into the section marked by the circle.


    1. Attach the 3 claws to the claw holes and install the No. 1 fuel sub-tank.

    2. Attach the 3 claws to the claw holes.

    3. A01X2SWE02
      Text in Illustration
      *1 Jet Pump

      Connect the jet pump (labeled B) to the No. 1 fuel sub-tank.


      1. Attach the claw on the end of the tube to the claw hole.

    4. Connect the jet pump (labeled A) to the No. 1 fuel sub-tank.

    5. Connect the fuel pump connector.

  6. INSTALL FUEL SENDER GAUGE ASSEMBLY

    Click here