REAR CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

    Click here

  4. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY

    Click here

  5. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)

    Click here

  6. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

    Click here

  7. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)

    Click here

  8. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

    Click here

  9. REMOVE REAR CRANKSHAFT OIL SEAL


    1. A01XAF0E04
      Text in Illustration
      *1 Cut Position
      *2 Oil Seal

      Using a knife, cut off the lip of the oil seal.

    2. Using a screwdriver, pry out the oil seal.

      Note

      Be careful not to damage the crankshaft.

      Tech Tips

      Tape the screwdriver tip before use.