FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL FRONT CRANKSHAFT OIL SEAL


    1. Apply MP grease to the lip of a new oil seal.

    2. B001ZZWE12

      Using SST and a hammer, tap in the oil seal to a depth between 0 and 1.0 mm (0 and 0.0394 in.) from the timing chain cover edge.

      SST
      09223-22010
      09506-35010

      Note


      • Keep the lip free from foreign matter.

      • Do not tap the oil seal at an angle.

  2. INSTALL CRANKSHAFT TIMING GEAR KEY


    1. Install the crankshaft timing gear key.

  3. INSTALL CRANKSHAFT PULLEY

    Click here

  4. INSTALL OIL FILTER BRACKET

    Click here

  5. INSTALL NO. 1 OIL COOLER BRACKET

    Click here

  6. CONNECT NO. 2 WATER BY-PASS PIPE SUB-ASSEMBLY


    1. Connect the 2 water by-pass hoses to the oil cooler.

    2. Install the 3 by-pass pipe bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  7. CONNECT COOLER COMPRESSOR ASSEMBLY

    Click here

  8. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY

    Click here

  9. INSTALL FAN SHROUD

    Click here

  10. INSTALL NO. 1 RADIATOR HOSE

  11. ADD ENGINE COOLANT

    Click here

  12. INSPECT FOR COOLANT LEAK

    Click here

  13. INSPECT FOR OIL LEAK

    Click here

  14. INSPECT ENGINE OIL LEVEL

    Click here

  15. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here

  16. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  17. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

    Click here

  18. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here