DRIVE BELT INSTALLATION

PROCEDURE


  1. INSTALL FAN AND GENERATOR V BELT


    1. B001ZUUE11
      Text in Illustration
      *1 Water Pump Pulley
      *2 Fan Pulley
      *3 No. 1 Idler Pulley
      *4 Vane Pump Pulley
      *5 Generator Pulley
      *6 V-ribbed Belt Tensioner
      *7 Crankshaft Pulley
      *8 Cooler Compressor Pulley

      Set the fan and generator V belt onto every part.

    2. While turning the belt tensioner counterclockwise, remove the pin.

      Note

      Make sure that the fan and generator V belt is properly set on each pulley.

    3. Check that the belt fits properly in the ribbed grooves.

      Tech Tips

      Make sure to check by hand that the belt has not slipped out of the grooves on the bottom of the pulley.

  2. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  3. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

    Click here

  4. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here

  5. INSTALL V-BANK COVER SUB-ASSEMBLY


    1. A01WZMQE01
      Text in Illustration
      *1 Grommet
      *2 Pin
      *3 Hook
      *4 Bracket

      Attach the 2 V-bank cover hooks to the bracket. Then align the 3 V-bank cover grommets with the 3 pins, and press down on the V-bank cover to attach the pins.