ECD SYSTEM(w/o DPF), Diagnostic DTC:P0606, P0607, P1611

DTC Code DTC Name
P0606 ECM / PCM Processor
P0607 Control Module Performance
P1611 IC Circuit Malfunction

DESCRIPTION

P0606, P0607, P1611
DTC Detection Drive Pattern DTC Detection Condition Trouble Area
Ignition switch ON for 1 second ECM internal error continues for 1 second (1 trip detection logic). ECM

CAUTION / NOTICE / HINT

Note

After replacing the ECM, the new ECM needs registration (See page ) and initialization Click here.

Tech Tips

Read freeze frame data using the intelligent tester. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, and other data from the time the malfunction occurred.

PROCEDURE


  1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0606, P0607 AND/OR P1611)


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to ON and turn the tester on.

    3. Enter the following menus: Powertrain / Engine / DTC.

    4. Read the DTCs.

      Result
      Result Proceed to
      P0606, P0607 or P1611 is output A
      P0606, P0607 or P1611 and other DTCs are output B

    B

    GO TO DTC CHART Click here

    A

  2. REPLACE ECM


    1. Replace the ECM Click here.


    NEXT

  3. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED


    1. Connect the intelligent tester to the DLC3.

    2. Clear the DTCs Click here.

    3. Turn the ignition switch off.

    4. Turn the ignition switch to ON for 1 second.

    5. Enter the following menus: Powertrain / Engine / DTC.

    6. Confirm that the DTC is not output again.


    NEXT

    END