POWER STEERING OIL PRESSURE SWITCH INSTALLATION

PROCEDURE


  1. INSTALL POWER STEERING OIL PRESSURE SWITCH


    1. Install a new O-ring to the oil pressure switch.

    2. Apply a light coat of engine oil to the O-ring of the oil pressure switch.

      Note


      • When reusing the oil pressure switch, inspect the O-ring.

      • If the O-ring has scratches or cuts, replace the new O-ring.

    3. Using a 24 mm deep socket wrench, install the oil pressure switch.

      Torque:
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

    4. Connect the oil pressure switch connector.

  2. INSTALL FAN AND GENERATOR V BELT

    Click here

  3. INSTALL AIR CLEANER ASSEMBLY

    Click here

  4. INSTALL AIR CLEANER HOSE ASSEMBLY

    Click here

  5. ADD POWER STEERING FLUID

  6. BLEED POWER STEERING FLUID


    1. Check the fluid level.

    2. Jack up the front of the vehicle and support it with stands.

    3. Turn the steering wheel.


      1. With the engine stopped, turn the wheel slowly from lock to lock several times.

    4. Lower the vehicle.

    5. Start the engine.

    6. Idle the engine for a few minutes.

    7. Turn the steering wheel.


      1. With the engine idling, turn the wheel left or right to the full lock position and keep it there for 2 to 3 seconds, then turn the wheel to the opposite full lock position and keep it there for 2 to 3 seconds. *1

      2. Repeat *1 several times.

        Note

        For vehicles with VGRS, if the steering wheel is turned from lock to lock repeatedly, the system may stop operating and the amount of rotation before the steering wheel locks may increase due to operation of the overheating prevention function. When the system temperature drops, the system operation automatically returns to normal.

    8. Stop the engine.

    9. B001XIHE03
      Text in Illustration
      *a Correct
      *b Incorrect

      Check for foaming or emulsification.

      If the system has to be bled twice because of foaming or emulsification, check for fluid leaks in the system.

    10. Check the fluid level.

  7. INSPECT FOR POWER STEERING FLUID LEAK

  8. INSTALL FRONT FENDER APRON SEAL FRONT RH

    Click here

  9. INSTALL FRONT WHEEL

  10. INSTALL V-BANK COVER SUB-ASSEMBLY

    Click here

  11. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  12. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

    Click here

  13. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here