THROTTLE BODY REMOVAL

PROCEDURE


  1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

    Click here

  2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here

  3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  4. DRAIN ENGINE COOLANT

    Click here

  5. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  6. REMOVE AIR CLEANER CAP AND HOSE


    1. A01X65H

      Disconnect the No. 2 PCV hose and No. 1 air hose.

    2. Disconnect the mass air flow meter connector and detach the clamp.

    3. Detach the 4 clamps.

    4. Loosen the hose clamp and remove the air cleaner cap and hose.

  7. REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY


    1. A01X0OL

      Disconnect the No. 4 water by-pass hose and No. 12 water by-pass hose.

    2. Disconnect the throttle position sensor and control motor connector.

    3. B001VXZ

      Remove the 4 bolts, throttle body with motor assembly and gasket.

    4. A01X1PG

      Remove the No. 12 water by-pass hose from the throttle body with motor assembly.

    5. A01WZV9

      Remove the No. 4 water by-pass hose from the throttle body with motor assembly.