HEATED OXYGEN SENSOR INSTALLATION

PROCEDURE


  1. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)


    1. B001WGI

      Temporarily install the sensor to the exhaust pipe by hand.

    2. A01X8LRE02
      *1 Fulcrum Length

      Using SST, tighten the sensor.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Tech Tips


      • Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). If using a torque wrench with a length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification Click here.

      • Make sure SST and the wrench are connected in a straight line.

    3. A01X25VE02
      *1 for Manual Transmission:
      *2 for Automatic Transmission:

      Connect the sensor connector.

  2. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)


    1. B001WGI

      Temporarily install the sensor to the exhaust pipe by hand.

    2. A01XBX2E01
      *1 Fulcrum Length

      Using SST, tighten the sensor.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Tech Tips


      • Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). If using a torque wrench with a length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification Click here.

      • Make sure SST and the wrench are connected in a straight line.

  3. INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY


    1. Install 2 new gaskets to the front No. 2 exhaust pipe.

    2. A01WZUY

      Connect the front No. 2 exhaust pipe to the exhaust manifold LH with 2 new nuts.

      Torque:
      54 N*m  { 554 kgf*cm, 40 ft.*lbf }

    3. Connect the front No. 2 exhaust pipe to the center exhaust pipe with the 2 bolts.

      Torque:
      48 N*m  { 489 kgf*cm, 35 ft.*lbf }
    4. A01WZC0E02
      *1 for Manual Transmission:
      *2 for Automatic Transmission:

      Connect the heated oxygen sensor connector.

      Tech Tips

      Hook the wire harness to the bracket.

  4. INSPECT FOR EXHAUST GAS LEAK

    Click here