SFI SYSTEM MIL Circuit

DESCRIPTION

The MIL (Malfunction Indicator Lamp) is used to indicate the detection of vehicle malfunctions by the ECM. When the ignition switch is turned to ON, power is supplied to the MIL circuit and the ECM provides the circuit ground which illuminates the MIL.

The MIL operation can be checked visually. When the ignition switch is first turned to ON, the MIL should be illuminated and should then turn off when the engine is started. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using the GTS.

WIRING DIAGRAM

A01X9NPE01

PROCEDURE


  1. CHECK WHETHER MIL IS ILLUMINATED


    1. Perform troubleshooting in accordance with the table below.

      Result
      Result Proceed to
      MIL remains on A
      MIL does not illuminate B

    B

    CHECK THAT MIL IS ILLUMINATED Click here

    A

  2. CHECK WHETHER MIL TURNS OFF


    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON and turn the GTS on.

    3. Check if DTCs have been stored Click here. If DTCs are output, write them down.

    4. Clear the DTCs Click here.

    5. Check that the MIL turns off.

      OK
      MIL turns off.

    OK

    REPAIR CIRCUITS INDICATED BY OUTPUT DTCS Click here

    NG

  3. CHECK HARNESS AND CONNECTOR (CHECK FOR SHORT IN WIRE HARNESS)


    1. Disconnect the ECM connector.

    2. Turn the ignition switch to ON.

    3. Check that the MIL is not illuminated.

      OK
      MIL is not illuminated.

    OK

    REPLACE ECM Click here

    NG

  4. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM)


    1. Disconnect the ECM connector.

    2. Disconnect the combination meter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      for LHD
      Tester Connection Condition Specified Condition
      E8-12 (CHK) or A38-24 (W) - Body ground Always 10 kΩ or higher
      for RHD
      Tester Connection Condition Specified Condition
      E8-12 (CHK) or A52-24 (W) - Body ground Always 10 kΩ or higher

    OK

    REPLACE COMBINATION METER ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

  5. CHECK THAT MIL IS ILLUMINATED


    1. Check if the MIL is illuminated when the ignition switch is turned to ON.

      OK
      MIL illuminates.

    OK

    SYSTEM OK

    NG

  6. CHECK THAT ENGINE STARTS


    1. Turn the ignition switch to ON.

    2. Start the engine.

      Result
      Result Proceed to
      Engine starts A
      Engine does not start* B

      Tech Tips

      *: The GTS cannot communicate with the ECM.


    B

    GO TO VC OUTPUT CIRCUIT Click here

    A

  7. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM)


    1. Disconnect the ECM connector.

    2. Disconnect the combination meter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      for LHD
      Tester Connection Condition Specified Condition
      E8-12 (CHK) - A38-24 (W) Always Below 1 Ω
      for RHD
      Tester Connection Condition Specified Condition
      E8-12 (CHK) - A52-24 (W) Always Below 1 Ω

    OK

    REPLACE COMBINATION METER ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR