ENGINE SWITCH INSPECTION

PROCEDURE


  1. INSPECT ENGINE SWITCH


    1. A01X6UTE07
      Text in Illustration
      *a

      Component without harness connected

      (Engine Switch)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      5 (SS1) - 6 (AGND) Not pushed 10 kΩ or higher
      1 (SS2) - 6 (AGND) Not pushed 10 kΩ or higher
      5 (SS1) - 6 (AGND) Pushed Below 1 Ω
      1 (SS2) - 6 (AGND) Pushed Below 1 Ω

      If the result is not as specified, replace the engine switch.

    2. A01X6UTE08
      Text in Illustration
      *a

      Component without harness connected

      (Engine Switch)

      Apply battery voltage between the terminals of the switch, and check the illumination condition of the switch.

      OK
      Measurement Condition Specified Condition

      Battery positive (+) → Terminal 9 (SWIL)

      Battery negative (-) → Terminal 6 (AGND)

      		 Illuminates

      Note


      • If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.

      • If the voltage is too low, the indicator will not illuminate.

      If the result is not as specified, replace the engine switch.