1GR-FE STARTING SERVICE DATA

Starter Specified current 90 A or less at 11.5 V
Magnet starter switch Terminal 50 - Terminal C Standard resistance Below 1 Ω
Terminal 50 - Switch body Standard resistance Below 2 Ω
Brush Brush length Standard length 15.5 mm (0.610 in.)
Minimum length 8.5 mm (0.335 in.)
Starter brush holder Brush spring Standard spring load 18 to 24 N (1.8 to 2.4 kgf, 4.0 to 5.3 lbf)
Minimum spring load 12N (1 kgf, 2.7 lbf)
Positive (+) brush holder - Negative (-) brush holder Standard resistance 10 Ω or higher
Starter yoke Lead wire - Brush Standard resistance Below 1 Ω
Starter yoke body - Brush Standard resistance 10 kΩ or higher
Starter armature Segment - Segment Standard resistance Below 1 Ω
Segment - Coil core Standard resistance 10 kΩ or higher
Circle runout Maximum circle runout 0.05 mm (0.00197 in.)
Commutator Standard diameter 30.0 mm (1.18 in.)
Minimum diameter 29.0 mm (1.14 in.)
Standard undercut depth 0.6 mm (0.0236 in.)
Minimum undercut depth 0.2 mm (0.00787 in.)
Starter relay 3 - 5 Standard resistance 10 kΩ or higher (Battery voltage is not applied to terminals 1 and 2)
Below 1 Ω (Battery voltage is applied to terminals 1 and 2)
Starter cut relay 3 - 5 Standard resistance 10 kΩ or higher (Battery voltage is not applied to terminals 1 and 2)
Below 1 Ω (Battery voltage is applied to terminals 1 and 2)

ACC relay

(Main body ECU)

 2A-1 - 2D-8 Standard resistance 10 kΩ or higher (Battery voltage is not applied between 2D-45 and 2D-62)
Below 1 Ω (Battery voltage is applied between 2D-45 and 2D-62)
Engine switch

2 - 5

7 - 5

 Standard resistance Below 1 Ω (Engine switch is pushed)
10 kΩ or higher (Engine switch is not pushed)
Ignition switch All combinations of all terminals Standard resistance 10 kΩ or higher (LOCK)
4 (AM1) - 2 (ACC) Standard resistance Below 1 Ω (ACC)

4 (AM1) - 2 (ACC)

4 (AM1) - 1 (IG1)

5 (AM2) - 6 (IG2)

 Standard resistance Below 1 Ω (ON)

4 (AM1) - 1 (IG1)

4 (AM1) - 3 (ST1)

5 (AM2) - 6 (IG2)

 Standard resistance Below 1 Ω (START)