STARTER INSTALLATION

PROCEDURE

1. INSTALL FLYWHEEL HOUSING SIDE COVER

2. INSTALL STARTER ASSEMBLY

   
   

   1. Install the starter with the 2 bolts.

      Torque:

      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

   2. Connect the starter wire with the nut.

      Torque:

      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

   3. Connect the terminal cap.

   4. Connect the starter connector.

   5. Connect the ground wire with the bolt.

      Torque:

      13 N*m  { 130 kgf*cm, 9 ft.*lbf }

3. INSTALL STARTER COVER

   
   

   1. Install the starter cover with the 3 bolts.

      Torque:

      12 N*m  { 117 kgf*cm, 8 ft.*lbf }

4. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH

   Click here

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.