OIL LEVEL SENSOR INSTALLATION

PROCEDURE


  1. INSTALL ENGINE OIL LEVEL SENSOR


    1. Install a new gasket to the sensor.

    2. A01X3VV

      Install the sensor with the 4 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

    3. Connect the sensor connector.

  2. CONNECT OIL COOLER TUBE (for Automatic Transmission)


    1. A01X50NE02

      Temporarily install the oil cooler tube to the engine with the 2 bolts A and B.

    2. Install the bolt C and tighten it to the specified torque. Then tighten the bolt A and B to the specified torque.

      Torque:
      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

  3. ADD ENGINE OIL

    Click here

  4. INSPECT FOR ENGINE OIL LEAK

    Click here

  5. CHECK ENGINE OIL LEVEL

    Click here

  6. INSTALL NO. 2 ENGINE UNDER COVER

    Click here

  7. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  8. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here

  9. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

    Click here

  10. INSTALL FRONT FENDER APRON SEAL REAR RH

    Click here

  11. INSTALL FRONT FENDER APRON SEAL FRONT RH

    Click here

  12. INSTALL FRONT WHEEL RH

    Click here