OIL PRESSURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL OIL PRESSURE SENDER GAUGE ASSEMBLY


    1. Apply adhesive to 2 or 3 threads of the oil pressure sender gauge.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      Note

      Do not apply adhesive to the oil inlet port of the oil pressure sender gauge.

      B001Z7PE02
      Text in Illustration
      *1 Oil Inlet Port

    2. Install the oil pressure sender gauge.

      Torque:
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine within 1 hour after installation.

    3. Connect the oil pressure sender gauge connector.

  2. INSPECT ENGINE OIL LEVEL

    Click here

  3. INSPECT FOR OIL LEAK

    Click here

  4. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

    Click here

  5. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here

  6. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

    Click here