OIL PRESSURE SENSOR INSTALLATION

PROCEDURE

1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY

   
   

   1. Apply adhesive to 2 or 3 threads of the oil pressure switch.

      Adhesive
      Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

      Note

      Do not apply adhesive to the oil inlet port of the oil pressure switch.

   2. Install the oil pressure switch.

      Torque:

      15 N*m  { 153 kgf*cm, 11 ft.*lbf }

      Note

      Do not start the engine within 1 hour of installation.

   3. Connect the oil pressure switch connector.

2. INSPECT FOR OIL LEAK

   Click here

3. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

   Click here

4. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

   Click here

5. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

   Click here