TURBO MOTOR DRIVER REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here

  4. REMOVE FRONT FENDER LINER RH

    Click here

  5. REMOVE TURBO MOTOR DRIVER


    1. A01X936E02
      Text in Illustration
      *a Claw

      Disconnect the connector.


      1. Disconnect the connector as follows: (1) push the claw upward, and (2) move the lock lever to release the lock.

    2. A01X5DD

      Remove the 2 nuts, bolt and turbo motor driver.

      Note

      If the turbo motor driver has been struck or dropped, replace it.