EXHAUST PIPE INSTALLATION

PROCEDURE


  1. INSTALL FRONT EXHAUST PIPE ASSEMBLY


    1. Install a new gasket and the front exhaust pipe to the exhaust manifold RH with 2 new nuts.

      Torque:
      54 N*m  { 554 kgf*cm, 40 ft.*lbf }

    2. Connect the heated oxygen sensor connector.

  2. INSTALL HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)

    Click here

  3. INSTALL FRONT NO. 2 EXHAUST PIPE ASSEMBLY


    1. Install a new gasket and the front No. 2 exhaust pipe to the exhaust manifold LH with 2 new nuts.

      Torque:
      54 N*m  { 554 kgf*cm, 40 ft.*lbf }
    2. A01X65CE02
      *1 for Automatic Transmission:
      *2 Bracket
      *3 for Manual Transmission:

      Connect the heated oxygen sensor connector.

      Tech Tips

      Hook the wire harness to the bracket.

  4. INSTALL CENTER EXHAUST PIPE ASSEMBLY


    1. A01X6L2

      Check the free length.


      1. Using a vernier caliper, measure the free length of the compression spring.

        Minimum free length
        43 mm (1.693 in.)

        If the free length is less than the minimum, replace the compression spring.

    2. Connect the center exhaust pipe to the 3 exhaust pipe supports.

    3. Install 2 new gaskets to the front exhaust pipe and front No. 2 exhaust pipe.

    4. Install the center exhaust pipe with the 4 bolts and 2 compression springs.

      Torque:
      for center exhaust pipe and front exhaust pipe
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }
      for center exhaust pipe and front No. 2 exhaust pipe
      48 N*m  { 489 kgf*cm, 35 ft.*lbf }

  5. INSTALL TAILPIPE ASSEMBLY


    1. Install the tailpipe to the 2 exhaust pipe supports.

    2. Set a new gasket to the center exhaust pipe.

    3. A01X0MYE08
      *1 Upper
      *2 LH Side
      *3 Front
      *4 Gasket

      Connect the tailpipe to the center pipe with a new clamp.

      Torque:
      32 N*m  { 326 kgf*cm, 24 ft.*lbf }

      Tech Tips

      Install the clamp within the angle range shown in the illustration.

  6. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

    Click here

  7. INSPECT FOR EXHAUST GAS LEAK

    Click here