SNORKEL AIR CLEANER REMOVAL

PROCEDURE


  1. REMOVE AIR PRE-CLEANER ASSEMBLY


    1. A01X9UA

      Remove the bolt, air pre-cleaner and No. 2 inlet air cleaner bracket.

  2. REMOVE COOL AIR INTAKE DUCT


    1. A01X6TI

      Remove the 2 bolts and cool air intake duct.

  3. REMOVE COOL AIR INTAKE PIPE RETAINER


    1. A01X0P2

      Remove the 2 bolts and cool air intake pipe retainer.

  4. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

    Click here

  5. REMOVE FRONT FENDER LINER RH


    1. Remove the screw and disconnect the liner from the front bumper cover.

    2. Using a T30 "TORX" socket, remove the 3 screws.

    3. Remove the 5 clips.

      Tech Tips

      It is not necessary to fully remove the fender liner. Partially remove it so that the air pump can be removed.

  6. REMOVE NO. 1 INLET AIR CLEANER


    1. A01X9IN

      Remove the 2 bolts.

    2. Detach the claw shown in the illustration, and then remove the No. 1 inlet air cleaner.

  7. REMOVE AIR CLEANER ASSEMBLY


    1. Disconnect the mass air flow meter connector and using a clip remover, detach the wire harness clamp from the air cleaner cap.

    2. Using a clip remover, detach the wire harness clamp from the air cleaner case.

    3. Remove the 3 bolts and air cleaner case.

  8. REMOVE NO. 2 INLET AIR CLEANER


    1. A01X3H4

      Remove the 2 bolts and inlet air cleaner.

  9. REMOVE INLET AIR CLEANER SEAL BRACKET SUB-ASSEMBLY


    1. A01X94A

      Remove the 2 bolts and inlet air cleaner seal bracket.