CANISTER(w/ Secondary Air Injection System) INSPECTION

PROCEDURE

1. Click here

   INSPECT CHARCOAL CANISTER

   
   
   1. 

      Visually check the canister for cracks or damage.

      Table 1. Text in Illustration

      *a	Port A
      *b	Port B
      *c	Port C
      	Air

   2. Blow compressed air of 4.9 kPa (0.05 kgf/cm², 0.7 psi) into port A and check that air flows without resistance from port B and port C.

      If the result is not as specified, replace the canister.

   3. Apply a vacuum of 1.96 kPa (15 mmHg, 0.579 in.Hg) to port A. Check that the vacuum does not decrease when ports B and C are closed, and check that air flows when port B is opened.

      If the result is not as specified, replace the canister.

2. Click here

   CLEAN FILTER IN CANISTER

   
   
   1. 

      Clean the filter by blowing compressed air of 4.9 kPa (0.05 kgf/cm², 0.7 psi) into port A while holding port B closed.

      Table 2. Text in Illustration

      *a	Port A
      *b	Port B
      	Air

      Note:

      Do not attempt to wash the canister.