FUEL SENDER GAUGE ASSEMBLY(for Fuel Sub Tank) INSTALLATION

PROCEDURE


  1. INSTALL FUEL SENDER GAUGE ASSEMBLY


    1. Install a new gasket to the fuel sender gauge assembly.

    2. Install the sender gauge with the 5 screws.

      Torque:
      1.5 N*m  { 15 kgf*cm, 13 in.*lbf }

      Note

      Be careful not to bend the arm of the fuel sender gauge assembly.

    3. Connect the fuel sender gauge connector.

  2. INSTALL REAR FLOOR SERVICE HOLE COVER


    1. B001ZRS

      Install the rear floor service hole cover with new butyl tape.

  3. INSTALL REAR NO. 7 AIR DUCT (w/ Rear Air Conditioning System)


    1. B001YTEE02

      Attach the 4 clips to install the rear No. 7 air duct.

      Tech Tips

      Attach the clips in the order shown in the illustration.

  4. INSTALL REAR FLOOR MAT ASSEMBLY


    1. B001VKH

      Attach the 5 clips to install the rear floor mat assembly.

  5. INSTALL REAR AIR DUCT GUIDE (w/ Rear Air Conditioning System)

    Click here

  6. INSTALL AIR DUCT PLUG (w/ Rear Air Conditioning System)

    Click here

  7. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH


  8. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH


  9. INSTALL REAR SEAT COVER CAP (w/ Rear No. 2 Seat, except Face to Face Seat Type)

    Click here

  10. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE

    Click here

  11. INSTALL REAR DOOR SCUFF PLATE LH

    Click here

  12. INSTALL REAR DOOR SCUFF PLATE RH

    Click here

  13. INSTALL REAR STEP COVER

    Click here

  14. INSTALL REAR NO. 2 SEAT ASSEMBLY


  15. INSTALL REAR NO. 1 SEAT ASSEMBLY RH (for 60/40 Split Seat Type 40 Side)

    Click here

  16. INSTALL REAR NO. 1 SEAT ASSEMBLY LH (for 60/40 Split Seat Type 60 Side)

    Click here

  17. INSTALL CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.


    1. Connect the cables to the negative (-) main battery and sub-battery terminals.

  18. CHECK SRS WARNING LIGHT

    Click here