FUEL SENDER GAUGE ASSEMBLY(for Fuel Sub Tank) INSTALLATION

PROCEDURE


  1. INSTALL FUEL SENDER GAUGE ASSEMBLY


    1. A01X27W

      Install a new gasket to the sender gauge.

    2. Install the sender gauge with the 5 screws.

      Torque:
      1.5 N*m  { 15 kgf*cm, 13 in.*lbf }

      Note

      Be careful not to bend the arm of the fuel sender gauge.

    3. Connect the sender gauge connector.

  2. INSTALL REAR FLOOR SERVICE HOLE COVER


    1. B001ZRS

      Install the service hole cover with new butyl tape.

  3. INSTALL REAR NO. 7 AIR DUCT (w/ Rear Air Conditioning System)


    1. B001YTEE02

      Attach the 4 clips to install the air duct.

      Tech Tips

      Attach the clips in the order shown in the illustration.

  4. INSTALL REAR FLOOR MAT ASSEMBLY


    1. B001VKH

      Attach the 5 clips to install the floor mat.

  5. INSTALL REAR AIR DUCT GUIDE (w/ Rear Air Conditioning System)

    Click here

  6. INSTALL AIR DUCT PLUG (w/ Rear Air Conditioning System)

    Click here

  7. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH


    1. w/ Sliding Roof:

      Install the front quarter trim panel assembly LH Click here.

    2. w/o Sliding Roof:

      Install the front quarter trim panel assembly LH Click here.

  8. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY RH


    1. w/ Sliding Roof:

      Install the front quarter trim panel assembly RH Click here.

    2. w/o Sliding Roof:

      Install the front quarter trim panel assembly RH Click here.

  9. INSTALL REAR SEAT COVER CAP (w/ Rear No. 2 Seat, except Face to Face Seat Type)

    Click here

  10. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE

    Click here

  11. INSTALL REAR DOOR SCUFF PLATE LH

    Click here

  12. INSTALL REAR DOOR SCUFF PLATE RH

    Click here

  13. INSTALL REAR STEP COVER

    Click here

  14. INSTALL REAR NO. 2 SEAT ASSEMBLY


    1. for Face to Face Seat Type:

      Install the rear No. 2 seat assembly Click here.

    2. except Face to Face Seat Type:

      Install the rear No. 2 seat assembly Click here.

  15. INSTALL REAR NO. 1 SEAT ASSEMBLY RH (for 60/40 Split Seat Type 40 Side)


    1. Install the rear No. 1 seat assembly RH Click here.

  16. INSTALL REAR NO. 1 SEAT ASSEMBLY LH (for 60/40 Split Seat Type 60 Side)


    1. Install the rear No. 1 seat assembly LH Click here.

  17. INSTALL CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.


    1. Connect the cables to the negative (-) main battery and sub-battery terminals.

  18. CHECK SRS WARNING LIGHT


    1. Check the SRS warning light Click here.