FUEL SENDER GAUGE ASSEMBLY(for Fuel Sub Tank) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.


    1. Disconnect the cables from the negative (-) main battery and sub-battery terminals.

  3. REMOVE REAR NO. 1 SEAT ASSEMBLY RH (for 60/40 Split Seat Type 40 Side)

    Click here

  4. REMOVE REAR NO. 1 SEAT ASSEMBLY LH (for 60/40 Split Seat Type 60 Side)

    Click here

  5. REMOVE REAR NO. 2 SEAT ASSEMBLY


  6. REMOVE REAR STEP COVER

    Click here

  7. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  8. REMOVE REAR DOOR SCUFF PLATE RH

    Click here

  9. REMOVE REAR FLOOR MAT REAR SUPPORT PLATE

    Click here

  10. REMOVE REAR SEAT COVER CAP (w/ Rear No. 2 Seat, except Face to Face Seat Type)

    Click here

  11. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH


  12. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH


  13. REMOVE AIR DUCT PLUG (w/ Rear Air Conditioning System)

    Click here

  14. REMOVE REAR AIR DUCT GUIDE (w/ Rear Air Conditioning System)

    Click here

  15. SEPARATE REAR FLOOR MAT ASSEMBLY

    B001VKH

    1. w/ Rear Air Conditioning System:

      Detach the 5 clips and fold back the rear floor mat assembly toward the front of the vehicle.

      Tech Tips

      Fold back the rear floor mat assembly so that the rear No. 7 air duct can be removed.

    2. w/o Rear Air Conditioning System:

      Detach the 5 clips and fold back the rear floor mat assembly toward the front of the vehicle.

      Tech Tips

      Fold back the rear floor mat assembly so that the service hole cover can be removed.

  16. REMOVE REAR NO. 7 AIR DUCT (w/ Rear Air Conditioning System)


    1. B001YZ0

      Detach the 4 clips and remove the rear No. 7 air duct.

  17. REMOVE REAR FLOOR SERVICE HOLE COVER

    B001ZRS

  18. REMOVE FUEL SENDER GAUGE ASSEMBLY


    1. B001W6A

      Disconnect the fuel sender gauge connector.

    2. B001WK8

      Remove the 5 screws and fuel sender gauge assembly.

      Note

      Be careful not to bend the arm of the fuel sender gauge assembly.

    3. Remove the gasket from the fuel sender gauge assembly.