FUEL TEMPERATURE SENSOR REMOVAL

PROCEDURE


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH (w/ Viscous Heater)

    Click here

  3. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH (w/ Viscous Heater)

    Click here

  4. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Viscous Heater)

    Click here

  5. REMOVE UPPER RADIATOR SUPPORT SEAL (w/ Viscous Heater)

    Click here

  6. DRAIN ENGINE COOLANT (w/ Viscous Heater)

    Click here

  7. REMOVE INTERCOOLER ASSEMBLY (w/ Intercooler)

    Click here

  8. REMOVE NO. 1 COOL AIR INLET (w/o Intercooler)

    Click here

  9. REMOVE NO. 2 COOL AIR INLET (w/o Intercooler)

    Click here

  10. DISCONNECT WATER HOSE SUB-ASSEMBLY (w/ Viscous Heater)

    Click here

  11. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  12. REMOVE NO. 1 AIR CLEANER HOSE

    Click here

  13. REMOVE INTAKE AIR CONNECTOR

    Click here

  14. REMOVE HEATER WATER PIPE SUB-ASSEMBLY (w/ Viscous Heater)

    Click here

  15. REMOVE NO. 1 AIR CLEANER PIPE SUB-ASSEMBLY

    Click here

  16. REMOVE FUEL TEMPERATURE SENSOR

    Note


    • Before replacing the fuel temperature sensor, be sure to clean the surrounding area.

    • When replacing the fuel temperature sensor, make sure that your hands are clean and do not use gloves, etc.

    • If the fuel temperature sensor is dropped, replace it with a new one.


    1. B001VRG

      Disconnect the fuel temperature sensor connector.

    2. Using SST, remove the fuel temperature sensor.

      SST
      09817-33190

    3. Remove the O-ring from the fuel temperature sensor.