FUEL SUPPLY PUMP INSPECTION

PROCEDURE


  1. INSPECT FUEL SUPPLY PUMP


    1. Inspect the suction control valve.


      1. A01X2ZQE02
        *a Component without harness connected: (Fuel Supply Pump)
        *b Suction Control Valve

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        1 - 2 20°C (68°F) 1.9 to 2.3 Ω

        If the result is not as specified, replace the fuel supply pump.

  2. INSPECT FUEL TEMPERATURE SENSOR


    1. Inspect the fuel temperature sensor Click here.

      If the result is not as specified, replace the fuel temperature sensor.