STARTER INSTALLATION

PROCEDURE

1. INSTALL STARTER ASSEMBLY

   
   

   1. Install the flywheel housing side cover.

   2. Install the starter with the 2 bolts.

      Torque:

      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

   3. Install the starter wire with the nut.

      Torque:

      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

   4. Connect the starter connector.

2. INSTALL STARTER COVER

   
   

   1. Install the starter cover with the 3 bolts.

      Torque:

      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

3. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH

   Click here

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.