ВЫПУСКНАЯ ТРУБА УСТАНОВКА

PROCEDURE


  1. INSTALL FRONT EXHAUST PIPE ASSEMBLY


    1. A004ZA1

      Using a vernier caliper, measure the free length of the compression springs.

      Minimum 41.5 mm (1.63 in.)

      Tech Tips

      If the free length is less than minimum, replace the compression spring.

    2. Temporarily install a new gasket to the exhaust manifold.

    3. A004XRSE52
      Text in Illustration
      *1 Exhaust Manifold
      *2 Gasket
      *a Wooden Block

      Using a plastic hammer and wooden block, tap in the gasket until its surface is flush with the exhaust manifold.

      Note


      • Be careful with the installation direction of the gasket.

      • Do not reuse the gasket.

      • Do not damage the gasket.

      • Do not push in the gasket by using the exhaust pipe when connecting it.

    4. Connect the front exhaust pipe assembly to the 2exhaust pipe supports.

    5. A004WZJ

      Install the front exhaust pipe assembly with the 2 bolts and 2 compression springs.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

  2. INSTALL HEATED OXYGEN SENSOR

    Click here

  3. INSTALL FRONT CENTER FLOOR BRACE


    1. A004Z4C

      Install the front center floor brace with the 4 bolts.

      Torque:
      51 N*m  { 520 kgf*cm, 38 ft.*lbf }

  4. INSTALL FRONT NO. 3 ENGINE UNDER COVER


    1. A004YG5

      Install the front No. 3 engine under cover with the 4 clips.

  5. INSTALL TAIL EXHAUST PIPE ASSEMBLY


    1. A004ZA1

      Using a vernier caliper, measure the free length of the compression springs.

      Minimum 38.5 mm (1.52 in.)

      Tech Tips

      If the free length is less than minimum, replace the compression spring.

    2. Temporarily install a new gasket to the front exhaust pipe assembly.

    3. A004XRSE52
      Text in Illustration
      *1 Front Exhaust Pipe Assembly
      *2 Gasket
      *a Wooden Block

      Using a plastic hammer and wooden block, tap in the gasket until its surface is flush with the front exhaust pipe assembly.

      Note


      • Be careful with the installation direction of the gasket.

      • Do not reuse the gasket.

      • Do not damage the gasket.

      • Do not push in the gasket by using the exhaust pipe when connecting it.

    4. Connect the tail exhaust pipe assembly to the 3 exhaust pipe supports.

    5. A004WFS

      Install the tail exhaust pipe assembly with the 2 bolts and 2 compression springs.

      Torque:
      43 N*m  { 438 kgf*cm, 32 ft.*lbf }

  6. INSPECT FOR EXHAUST GAS LEAK