ВЫПУСКНОЙ КОЛЛЕКТОР СНЯТИЕ

PROCEDURE


  1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

    Click here

  2. REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL

    Click here

  3. REMOVE NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL

    Click here

  4. REMOVE COWL BODY MOUNTING REINFORCEMENT LH

    Click here

  5. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY

    Click here

  6. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  7. REMOVE NO. 1 ENGINE UNDER COVER

  8. REMOVE FRONT NO. 3 ENGINE UNDER COVER

    Click here

  9. REMOVE FRONT CENTER FLOOR BRACE

    Click here

  10. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    1. A004Y4C

      Disconnect the 3 clamps and heated oxygen sensor connector.

    2. A004WRN

      Remove the 4 bolts and 4 compression springs.

    3. Remove the front exhaust pipe assembly from the 2 exhaust pipe supports.

    4. Remove the 2 gaskets from the front exhaust pipe assembly and exhaust manifold.

  11. REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR


    1. A004Y9B

      Remove the 3 nuts and front No. 1 floor heat insulator.

  12. REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR


    1. A004WBK

      Remove the 3 bolts and No. 1 exhaust manifold heat insulator.

  13. REMOVE AIR FUEL RATIO SENSOR

    Click here

  14. REMOVE MANIFOLD STAY


    1. A004XIA

      Remove the 3 bolts and manifold stay.

  15. REMOVE EXHAUST MANIFOLD


    1. A004Y8J

      Remove the 5 nuts, exhaust manifold and gasket.

  16. REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR


    1. A004WA4

      Remove the 3 bolts and No. 2 exhaust manifold heat insulator.