ВПУСКНОЙ КОЛЛЕКТОР УСТАНОВКА

PROCEDURE


  1. INSTALL INTAKE MANIFOLD


    1. w/ Stud Bolt:


      1. Using an E6 "TORX" socket wrench, install the 2 stud bolts from the intake manifold.

        Torque:
        5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

        Tech Tips

        If a stud bolt is deformed or the threads are damaged, replace the stud bolt.

    2. Install a new No. 1 intake manifold to head gasket to the intake manifold.

    3. A00502D

      Install the intake manifold with the 2 bolts and 2 nuts.

      Torque:
      28 N*m  { 286 kgf*cm, 21 ft.*lbf }
    4. A004WZ4

      Connect the fuel vapor feed hose and ventilation hose.

    5. Install a new O-ring to the engine oil level dipstick guide sub-assembly.

    6. Apply a light coat of engine oil to the O-ring.

    7. A004X83E03

      Install the engine oil level dipstick guide sub-assembly with the 2 bolts and connect the wire harness clamp.

      Torque:
      Bolt (A)
      28 N*m  { 286 kgf*cm, 21 ft.*lbf }
      Bolt (B)
      21 N*m  { 214 kgf*cm, 15 ft.*lbf }

    8. Install the engine oil level dipstick.

    9. A004VM8

      Connect the 2 wire harness clamps and 3 connectors.

    10. A004XXZ

      Install a new gasket and the surge tank cover with the 2 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }
    11. A004WR2

      Install the wire harness support with the bolt.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }
    12. A004XUZ

      Connect the 2 wire harness clamps.

  2. INSTALL PURGE VSV

    Click here

  3. INSTALL MANIFOLD ABSOLUTE PRESSURE SENSOR

    Click here

  4. INSTALL THROTTLE BODY ASSEMBLY

    Click here