ТОПЛИВНАЯ ФОРСУНКА СНЯТИЕ

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work Click here.

  2. DISCHARGE FUEL SYSTEM PRESSURE

    Click here

  3. REMOVE REAR NO. 2 FLOOR BOARD

    Click here

  4. REMOVE REAR DECK FLOOR BOX

    Click here

  5. REMOVE REAR NO. 3 FLOOR BOARD

    Click here

  6. REMOVE DECK FLOOR BOX RH

    Click here

  7. REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE

    Click here

  8. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  9. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  10. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  11. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  12. REMOVE WATER HOSE HOSE CLAMP

    Click here

  13. REMOVE INLET AIR CLEANER ASSEMBLY

    Click here

  14. REMOVE AIR CLEANER CASE

    Click here

  15. REMOVE AIR CLEANER HOSE ASSEMBLY

    Click here

  16. DISCONNECT ENGINE WIRE


    1. B001LDT

      Disconnect the 4 fuel injector connectors.

    2. Disconnect the 4 connectors.

    3. Remove the bolt.

    4. Disengage the 2 clamps to disconnect the wire harness.

  17. DISCONNECT FUEL TUBE SUB-ASSEMBLY


    1. B001MCP

      Release the claw and remove the No. 1 fuel pipe clamp.

    2. B001KBO

      Pinch the retainer of the fuel tube connector, and then pull the fuel tube connector off of the fuel pipe.

      Note


      • Check for foreign matter in the fuel pipe around the fuel tube connector. Clean it if necessary. Foreign matter can affect the ability of the O-ring to seal the fuel tube connector and fuel pipe.

      • Do not use any tools to separate the fuel tube connector and fuel pipe.

      • Do not forcibly bend, kink or twist the fuel tube.

      • Keep the fuel tube connector and fuel pipe free from foreign matter.

      • If the fuel tube connector and fuel pipe are stuck together, pinch the fuel tube connector and turn it carefully to disconnect it.

      • Put the fuel tube connector and fuel pipe in plastic bags to prevent damage and contamination.

  18. SEPARATE WATER BY-PASS PIPE


    1. B001M4X

      Disengage the clamp to disconnect the wire harness.

    2. Remove the 2 bolts and nut, and separate the water by-pass pipe.

  19. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY


    1. B001LRU

      Remove the bolt.

    2. B001N4A

      Remove the 2 bolts and fuel delivery pipe sub-assembly.

      Note

      Be careful not to drop the fuel injectors when removing the fuel delivery pipe.

  20. REMOVE NO. 1 DELIVERY PIPE SPACER


    1. B001KZJ

      Remove the 2 delivery pipe spacers from the cylinder head.

  21. REMOVE FUEL INJECTOR ASSEMBLY


    1. B001N5Z

      Pull the 4 fuel injector assemblies out of the fuel delivery pipe sub-assembly.

    2. Remove the O-ring from each fuel injector assembly.

    3. For reinstallation, attach a tag or label to each injector shaft.

      Note

      Prevent entry of foreign matter by covering the fuel injectors with plastic bags.

    4. B001LDJ

      Remove the 4 injector vibration insulators.