ECM УСТАНОВКА

PROCEDURE


  1. INSTALL ECM


    1. Install the 2 ECM brackets to the ECM with the 4 screws.

    2. Install the ECM with the 2 bolts.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

    3. Connect the 2 ECM connectors.


      1. B001MQP

        Connect the 2 ECM connectors and lower the 2 levers.

        Note


        • When connecting the connectors, make sure that dirt, water or other foreign matter does not get caught between the connectors and other parts.

        • Make sure that the 2 levers are securely locked.

      2. Install the wire harness clamp.

  2. INSTALL INVERTER RESERVE TANK ASSEMBLY


    1. Install the inverter reserve tank assembly with the 2 bolts.

      Torque:
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }

  3. INSTALL INVERTER WITH CONVERTER ASSEMBLY

    Click here

  4. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL


    1. Connect the negative auxiliary battery cable with the nut.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. INSTALL REAR FLOOR BOARD UPPER NO. 3 PLATE

    Click here

  6. INSTALL DECK FLOOR BOX RH

    Click here

  7. INSTALL REAR NO. 3 FLOOR BOARD

    Click here

  8. INSTALL REAR DECK FLOOR BOX

    Click here

  9. INSTALL REAR NO. 2 FLOOR BOARD

    Click here

  10. PERFORM INITIALIZATION

    Note


    • Perform Initialization when replacing the ECM Click here.

    • When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.