ROOF DRIP SIDE FINISH MOULDING INSTALLATION

PROCEDURE

1. INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP

   Note

   When installing new clips, remove the double-sided tape remaining where the clips will be installed on the body and clean the body with a non-residue solvent.

   
   
   1. 

      Text in Illustration

      *1	Adhesive
      *a	2 to 3 mm Bead of Adhesive

      Apply a 2 to 3 mm (0.0787 to 0.118 in.) bead of adhesive (3M DP-105 or equivalent) to new roof drip side finish moulding clips.

      Tech Tips

      Adhesive strength (tensile strength): 13.7 MPa (140.0 kgf/cm², 1987 psi) or more (when the temperature is 23°C (73°F))

   2. Press and install the 2 roof drip side finish moulding clips.

   3. Install the clips to the positions on the roof panel shown in the illustration. Determine the locations and firmly press and install the 2 roof drip side finish moulding clips after lightly applying adhesive (3M DP-105 or equivalent).

      

      Text in Illustration

      *A	for Front Side	*B	for Rear Side
      *1	Protruding Part	-	-

      Standard Dimension

      Installation Area	Dimension	Measurement
      for Front Side	A	3.4 mm (0.134 in.)
      	B	2.6 mm (0.102 in.)
      	C	1.9 mm (0.0748 in.)
      	D	1.2 mm (0.0472 in.)
      for Rear Side	E	3.0 mm (0.118 in.)
      	F	3.0 mm (0.118 in.)
      	G	3.7 mm (0.146 in.)
      	H	2.0 mm (0.0787 in.)

   4. Install the roof drip center side finish moulding when 20 minutes or more have elapsed after pressing and installing 2 new roof drip side finish moulding clips.

      Tech Tips

      
      

      • Initial hardening time: 20 minutes

      • Complete hardening time: 48 hours

2. INSTALL CENTER ROOF DRIP SIDE FINISH MOULDING

   
   

   1. 

      Engage the 2 clips and install the center roof drip side finish moulding.