REAR DOOR BELT MOULDING INSTALLATION

PROCEDURE

1. INSTALL REAR DOOR BELT MOULDING ASSEMBLY

   
   

   1. 

      Engage the 5 claws and guide to install the rear door belt moulding assembly as shown in the illustration.

2. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

   Click here

3. INSTALL REAR DOOR QUARTER WINDOW GLASS

   Click here

4. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

   Click here

5. INSTALL NO. 1 REAR DOOR VENT SEAL

   Click here

6. INSTALL REAR DOOR GLASS RUN

   Click here

7. INSTALL REAR DOOR WEATHERSTRIP

   Click here

8. INSTALL REAR DOOR CHECK ASSEMBLY

   Click here

9. INSTALL REAR DOOR SERVICE HOLE COVER

   Click here

10. INSTALL REAR DOOR TRIM BRACKET

    Click here

11. INSTALL REAR DOOR SPEAKER COVER (w/o Rear Speaker)

    Click here

12. INSTALL REAR SPEAKER ASSEMBLY (w/ Rear Speaker)

    Click here

13. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

    Click here

14. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

15. INSTALL REAR DOOR ARMREST COVER

    Click here

16. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

17. INSTALL REAR DOOR REAR FRAME BRACKET

    Click here

18. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

19. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

20. INSTALL REAR FLOOR BOARD UPPER NO. 3 PLATE

    Click here

21. INSTALL DECK FLOOR BOX RH

    Click here

22. INSTALL REAR NO. 3 FLOOR BOARD

    Click here

23. INSTALL REAR DECK FLOOR BOX

    Click here

24. INSTALL REAR NO. 2 FLOOR BOARD

    Click here

25. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here