FRONT DOOR BELT MOULDING INSTALLATION
PROCEDURE
-
PRECAUTION
Note
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.
-
INSTALL FRONT DOOR BELT MOULDING ASSEMBLY
-
Engage the 7 claws to install the front door belt moulding assembly.
-
-
INSTALL FRONT DOOR FRONT LOWER FRAME UPPER COVER
-
INSTALL FRONT DOOR GLASS RUN
-
INSTALL FRONT DOOR GLASS SUB-ASSEMBLY
-
INSTALL FRONT DOOR SERVICE HOLE COVER
-
INSTALL FRONT DOOR TRIM BRACKET (for Driver Side)
-
INSTALL FRONT DOOR TRIM BRACKET (for Front Passenger Side)
-
INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY (for Driver Side)
-
INSTALL DOOR ARMREST COVER (for Driver Side)
-
INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
-
INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY (for Front Passenger Side)
-
INSTALL DOOR ASSIST GRIP ASSEMBLY (for Front Passenger Side)
-
INSTALL DOOR ASSIST GRIP COVER (for Front Passenger Side)
-
INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
-
INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH
-
INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG
-
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Note
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.
-
INSTALL REAR FLOOR BOARD UPPER NO. 3 PLATE
-
INSTALL DECK FLOOR BOX RH
-
INSTALL REAR NO. 3 FLOOR BOARD
-
INSTALL REAR DECK FLOOR BOX
-
INSTALL REAR NO. 2 FLOOR BOARD
-
INITIALIZE POWER WINDOW CONTROL SYSTEM