BACK DOOR OUTSIDE GARNISH INSTALLATION

PROCEDURE


  1. INSTALL SYMBOL EMBLEM

    Click here

  2. INSTALL BACK DOOR OUTSIDE GARNISH PROTECTOR


    1. Wipe off any tape adhesive residue with cleaner.

    2. Remove the release paper from the back door outside garnish protector.

      Tech Tips

      After removing the release paper, keep the exposed adhesive free from foreign matter.

    3. B001LY3C01
      *a Double-sided Tape

      Install a new back door outside garnish protector as shown in the illustration.

  3. INSTALL BACK DOOR UPPER OUTSIDE GARNISH LH


    1. Clean the back door outside garnish sub-assembly surface.


      1. Remove any double-sided tape from the luggage compartment door outside garnish sub-assembly.

      2. Wipe off any tape adhesive residue with cleaner.

    2. Install the back door upper outside garnish LH.


      1. Remove the release paper from the back door upper outside garnish LH.

        Tech Tips

        After removing the release paper, keep the exposed adhesive free from foreign matter.

      2. Install a new back door upper outside garnish LH as shown in the illustration.

      3. Install the screw.

  4. INSTALL BACK DOOR UPPER OUTSIDE GARNISH RH

    Tech Tips

    Use the same procedure as for the LH side.

  5. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY


    1. Install the new 2 clips (back door outside garnish clips) as shown in the illustration.

      B001KC0
    2. Install the new 6 clips (No. 2 back door outside garnish clips) as shown in the illustration.

      B001LQP
    3. B001N5WC02
      *a String
      *b Back Window Lower Moulding
      *c Masking Tape

      Pass a string behind the back window lower moulding and tape both ends with masking tape as shown in the illustration.

    4. B001KMW

      Engage the 8 clips to install the back door outside garnish sub-assembly.

      Tech Tips

      Make sure not to dislodge the string under the back window lower moulding.

    5. Apply soapy water to the back window lower moulding.

    6. B001MXMC01
      *1 Back Door Outside Garnish Sub-assembly
      *a Back Window Lower Moulding

      Pull out the string slowly, starting from one end and working to the other end, as shown in the illustration.

      Note

      Make sure not to damage the back window lower moulding.

    7. Check that the back window lower moulding is not caught behind the back door outside garnish sub-assembly.

    8. B001KP7

      Install the 2 screws.

  6. INSTALL BACK DOOR OPENER SWITCH ASSEMBLY

    Click here

  7. INSTALL REAR LIGHT ASSEMBLY LH

    Click here

  8. INSTALL REAR LIGHT ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.