HEADLIGHT LEVELING ECU(for RHD) REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.

  2. REMOVE REAR NO. 2 FLOOR BOARD

    Click here

  3. REMOVE REAR DECK FLOOR BOX

    Click here

  4. REMOVE REAR NO. 3 FLOOR BOARD

    Click here

  5. REMOVE DECK FLOOR BOX RH

    Click here

  6. REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE

    Click here

  7. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  8. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  9. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH

    Tech Tips

    Use the same procedure for the RH side and LH side Click here.

  10. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

  11. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

    Tech Tips

    Use the same procedure for the RH side and LH side Click here.

  12. REMOVE HEADLIGHT LEVELING ECU ASSEMBLY


    1. B001LN2

      Disconnect the connector.

    2. Remove the nut.

    3. Disengage the guide and remove the headlight leveling ECU assembly.