HEADLIGHT LEVELING ECU(for LHD) REMOVAL

PROCEDURE

1. PRECAUTION

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.

2. REMOVE REAR NO. 2 FLOOR BOARD

   Click here

3. REMOVE REAR DECK FLOOR BOX

   Click here

4. REMOVE REAR NO. 3 FLOOR BOARD

   Click here

5. REMOVE DECK FLOOR BOX RH

   Click here

6. REMOVE REAR FLOOR BOARD UPPER NO. 3 PLATE

   Click here

7. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

8. REMOVE FRONT DOOR SCUFF PLATE RH

   Tech Tips

   Use the same procedure for the RH side and LH side Click here.

9. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

   Tech Tips

   Use the same procedure for the RH side and LH side Click here.

10. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH

    Tech Tips

    Use the same procedure for the RH side and LH side Click here.

11. REMOVE INSTRUMENT SIDE PANEL RH

    Click here

12. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

13. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

    Click here

14. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

    Click here

15. REMOVE HEADLIGHT LEVELING ECU ASSEMBLY

    
    

    1. 

       Disconnect the connector.

    2. Remove the nut.

    3. Disengage the guide and remove the headlight leveling ECU assembly.