STOP LIGHT SWITCH INSTALLATION

PROCEDURE


  1. INSTALL STOP LIGHT SWITCH ASSEMBLY


    1. B001NDZ

      Insert the stop light switch assembly until the rod hits the pedal.

      Note

      When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

    2. B001N8R

      Make a quarter turn clockwise to install the stop light switch assembly.

      Torque:
      1.5 N*m  { 15 kgf*cm, 13 in.*lbf }
      or less

      Note

      When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.

    3. Connect the connector.

    4. Check the protrusion of the rod.

      Protrusion of the rod
      1.5 to 2.5 mm (0.0591 to 0.0984 in.)

      If the protrusion is not as specified, adjust it.

      Note

      Do not depress the brake pedal.

  2. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

    Click here

  3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for RHD)

    Click here